In this lesson students learn about the general idea of freezing point depression while reviewing solutions.
To begin the lesson I have student review what they learned in the previous lesson related to quantitative solution calculations. I do this by having students do whiteboard practice.
This is the PowerPoint that I use with students.
For details on how whiteboard practice works see my reflection on Partner Whiteboards in my Metallic and Covalent Bonds lesson.
Some of the common mistakes that students make while doing the whiteboards include:
In this section of the lesson I explain to students how they will be doing the lab.
I first give students several minutes to read the lab to themselves.
I then go over the procedures with students. I make sure to stress that when they are making the ice cream to seal the first bag really well. To help students see what they will be doing I show them an i-movie that my students made several years ago which goes over the procedures.
I let students know that we will be doing the lab at the back stations where it will be assembly-line fashioned.
Finally I tell students that once they are done with the prelab questions than they can come to the back to start the lab.
This is the part of the lesson where students are doing the lab.
Once they have their prelab questions complete they come to the back of the classroom where they make their ice cream solution in one bag and then put it into the salt/ice solution in a second bag.
I have this set up in the back of my classroom so that I can be in charge of pouring the milk/vanilla which helps to prevent spilling. This video explains how I do this in my classroom. At the first station I have students do everything for the first bag and then seal the bag before going to the next table. This is a picture of the setup at the first station.
At the second station, students put the salt/ice in the second bag. I have a temperature probe in the ice so that they can see the initial temperature of the ice. Here is a picture of the setup for the second station.
When students are done with making their two bags I have them go outside of my classroom to shake the bags together. On there way out of the door I have a stack of towels so that they can grab a towel to put around the plastic bags so that there hands don't freeze. I have them do this outside because the bags can leak salt-water which is very messy for my floors. After about 5 minutes when students' ice cream starts to solidify I have them come back into the classroom where I have a second temperature probe set up for them to find the final temperature of their ice-salt solution and then dump into a bucket. This is a picture of the setup at the final station.
Students then get a spoon and some chocolate chips and are able to enjoy their ice cream. As students are eating I encourage them to complete the questions on their labs. Here is a picture of what the final ice cream looks like.
When students are done with their labs I have them turn into my basket. I then grade their labs using the rubric.
This first graded example of a student lab shows how she earned most of her points, but did not put units on her data. Also if you notice she calculated the percent composition of both the salt and the water in the salt-water solution. Finally, she did a good job with her conclusion noting that she must have added too much salt because the final temperature was lower than what was expected.
In this second graded example the student also does not put units on his data. This student also does a good job with his conclusion and points out that the heat of his hands could have warmed the bag/ice to give him a higher temperature than expected.
In this third graded example the student misses points with his analysis for percent error. This was a common mistake where students used the percent yield equation instead of percent error.