Lesson: Marshmallow Catapults

David Kujawski Bird Middle East Walpole, MA
18782 Views
353 Downloads
87 Favorites

Lesson Objective

YWBAT: Apply the technological design steps to build a marshmallow catapult that uses the allotted materials to launch a marshmallow at least 5 meters in the air and within a 1/2 meter wide area.

Lesson Plan

Marshmallow Catapult Design Challenge Description

THIS WILL TAKE ABOUT A WEEK FROM START TO FINISH

Each group will design and build a marshmallow catapult using the following materials to achieve the goal:

 

1 meter of masking tape

 

2 Plastic cups

 

4 Rubber bands

 

2 Plastic spoons

 

2 Paperclips

 

15 cm x 15 cm Piece of cardboard

 

Large (standard size) marshmallows to launch

 

 

 

Goal: Launch a marshmallow at least 5 meters (in the air) and not outside of a ½ meter width.

Day 1: Assign activity and partners, discuss rubric, answer questions and allow students time to brainstorm a solution with their partner.  Students should individually design a solution and then share their design.

Day 2: Students should design a final solution and create orthographic projections of their design  HW: Draw their catapult as a technological system.

Day 3: Students will be given the materials above and will construct their catapults, leave about 5-10 minutes for clean-up and wrap-up.  Students should be recording their updates and redesigns in their journal (a few pieces of paper where they will identify constraints, trade-offs, modifications, etc.).

Day 4: Final construction and test!

Tips for test day:

Have students move the desks to the side of the room facing inward.  Designate a launch area and measure out a 5-meter line and a half a meter wide span.  This designates the acceptable landing area.

Safety: Everyone should wear safety goggles!  There will be flying marshmallows and rubberbands might come loose or snap--state these dangers to your students. 

Have the rubrics laid out with a pen ready to record the grades.  Remember: you'll be judging the quality of the construction before launching.  This will allow you to discard the catapults after the launch occurs. 

Don't forget to purchase marshmallows.  If you do forget, a piece of paper rolled into a ball will work.

Rubric and other worksheets, including graph paper, are attached to this lesson.

Enjoy!

Lesson Resources

Orthographic Projection Website (blue prints)
18782
Youtube video on orthographic projections
18782
designprocess  
2,688
graphpaper   Activity
1,239
microsoftword catapults   Activity
2,477
microsoftword researching   Activity
1,213
Catapult Picture   Exemplar
3,822
Catapult Picture   Exemplar
2,461
Trouble-shooting journal picture   Exemplar
1,040
Technological System Drawing.JPG  
1,232
New catapult rubric.pdf  
51

Comments


Cancel
No comments at this time.
Add Comment

Close

Something went wrong. See details for more info
Nothing to upload
details
close